Separate 1 rosebud from the bunch and straighten it's stem. Holding the rosebud upside down, begin by threading the 2 - 18mm Starflake beads onto the stem.
Next, add 2 - 12mm Starflake beads. Be sure that the Starflake beads nest themselves together on the stem then add the 3 - 6mm Faceted beads onto the stem.
Add the 12mm Faceted bead onto the stem and then add the 2 - 25mm Starflake beads onto the stem.
Using jewelry pliers pull the stem somewhat tight through the beads and then fold the stem to the outside of the vase, upward toward the rosebud and wiggle it up against the inside of the 2 - 25mm Starflakes. Once you have pushed it inside as far as you can, trim the stem and push the end toward the middle to conceal it.
(Optional) If your vase does not seem as sturdy as it should or seems to sway a little cut a 2" piece of 20 gauge wire and straighten it. Carefully push the wire up from the bottom of the vase, toward the rosebud, into the center of the beads, where the floral stem is. Push it in as far as you can and trim any excess.
Straighten your vase and then using any type of CLEAR drying household glue put a drop of glue into the center hole at the bottom of the vase and let dry.
Aren't they beautiful!
